2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Display)

E282730E05
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      3 - 16
      Hazard warning signal switch off
      10 kΩ or higher
      Hazard warning signal switch on
      Below 1 Ω

      If the result is not as specified, there may be a malfunction in the hazard warning signal switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Hazard Warning Signal Switch Assembly)

  1. Illumination inspection.

    1. E282730E04
      Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 11 (ILL+)
      Battery negative (-) → Terminal 8 (ILL-)
      Illuminates

      If the result is not as specified, there may be a malfunction in the hazard warning signal switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Hazard Warning Signal Switch Assembly)


INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/ Display)

E107908E21
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      4 - 1
      Hazard warning signal switch off
      10 kΩ or higher
      Hazard warning signal switch on
      Below 1 Ω

      If the result is not as specified, there may be a malfunction in the hazard warning signal switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Hazard Warning Signal Switch Assembly)

  1. E107908E19
    Illumination inspection.

    1. Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (ILL+)
      Battery negative (-) → Terminal 2 (ILL-)
      Illuminates

      If the result is not as specified, there may be a malfunction in the hazard warning signal switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Hazard Warning Signal Switch Assembly)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →