2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Clearance Warning Buzzer Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The clearance warning buzzer sounds to alert the driver. The sounding pattern changes according to the distance to the obstacle.

WIRING DIAGRAM

E194317E04

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (NO. 1 CLEARANCE WARNING BUZZER - CLEARANCE WARNING ECU)
  1. Disconnect the I1 clearance warning ECU connector.

  1. Disconnect the G161 No. 1 clearance warning buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I1-14 (BBZ) - G161-1 (Z+)
    Always
    Below 1 Ω
    I1-12 (EF) - G161-2 (Z-)
    Always
    Below 1 Ω
    I1-14 (BBZ) - Body ground
    Always
    10 kΩ or higher
    I1-12 (EF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning Buzzer Circuit (Aug 2013 – Jul 2014)Clearance Warning ECU Power Source Circuit (Aug 2013 – Jul 2014) →