Clearance Warning ECU Power Source Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit is the power source circuit used to operate the clearance warning ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY AND BODY GROUND) |
Disconnect the I1 clearance warning ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
I1-10 (IG) - Body ground
Ignition switch ON
11 to 14 V
I1-10 (IG) - Body ground
Ignition switch off
Below 1 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
I1-21 (E) - Body ground
Always
Below 1 Ω
| *a |
Front view of wire harness connector (to Clearance Warning ECU) |
|
|
||||
| OK | ||
| ||
