2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


CHECK TURN SIGNAL FLASHER ASSEMBLY

  1. E162022E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (LR) - 7 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    Alternating between 11 to 14 V and below 1 V
    (60 to 120 times per minute)
    3 (LL) - 7 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    Alternating between 11 to 14 V and below 1 V
    (60 to 120 times per minute)
    4 (B) - 7 (E)
    Always
    11 to 14 V
    5 (EL) - 7 (E)
    Ignition switch ON
    Headlight dimmer switch (turn left) off
    9 V or higher
    Ignition switch ON
    Headlight dimmer switch (turn left) on
    Below 1 V
    6 (ER) - 7 (E)
    Ignition switch ON
    Headlight dimmer switch (turn right) off
    9 V or higher
    Ignition switch ON
    Headlight dimmer switch (turn right) on
    Below 1 V
    8 (HAZ) - 7 (E)
    Hazard warning switch off
    9 V or higher
    Hazard warning switch on
    Below 1 V

    If the result is not as specified, there may be a malfunction in the turn signal flasher.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Turn Signal Flasher Assembly)

← COMPONENTS (from Aug 2013)REMOVAL (Aug 2013 – Jul 2014) →