INSTALLATION
Removal / installation · Vehicles built from Aug 2013
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
- Use the same procedure for the RH and LH sides.
| 1. INSTALL HEADLIGHT ASSEMBLY LH |
Put protective tape around the headlight assembly LH.
Connect each connector.
Install the headlight assembly LH with the bolt and 3 screws.
- Torque:
- for Bolt:
- 5.6 N*m{ 57 kgf*cm , 50 in.*lbf }


Text in Illustration *1
Protective Tape
*2
Bolt
*3
Screw
-
-
Install the clip.
| 2. INSTALL FRONT FENDER SIDE PANEL PROTECTOR LH |
Attach the 3 clips to install the front fender side panel protector LH.
| 3. INSTALL FRONT BUMPER COVER |
| 4. ADJUST HEADLIGHT AIMING |
| 5. ADJUST FOG LIGHT AIMING |
