2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL FRONT BUMPER BAR REINFORCEMENT LH
  1. Install the front bumper bar reinforcement LH with the 2 screws.


2. INSTALL FRONT BUMPER BAR REINFORCEMENT LH
  1. Install the front bumper bar reinforcement LH with the 2 screws.


3. INSTALL HEADLIGHT LEVELING MOTOR BASE PACKING
  1. Install a new headlight leveling motor base packing to the headlight unit LH.


4. INSTALL HEADLIGHT LEVELING MOTOR LH

  1. Hold the LED unit in place, and then push in the end of the headlight leveling motor LH to connect it to the LED unit and install the headlight leveling motor LH.

    E283090E01

    Text in Illustration 
    *1
    LED Unit
    *2
    End of Headlight Leveling Motor LH

  1. E283842
    Rotate the headlight leveling motor LH in the direction of the arrow shown in the illustration and attach the claw.

    HINT:
    For the headlight leveling motor RH, rotate it in the opposite direction of the arrow shown in the illustration to install it.

  1. Connect the connector.


5. INSTALL HEADLIGHT GASKET
  1. Install a new headlight gasket to the headlight socket cover.


6. INSTALL HEADLIGHT SOCKET COVER
  1. Attach the guide to install the headlight socket cover.

  1. Install the screw.


7. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH
  1. Connect the connector.

  1. E281070
    Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow to install it.


8. INSTALL FRONT TURN SIGNAL LIGHT BULB

  1. E282551
    Install the front turn signal light bulb to the front turn signal light bulb socket.

  1. E282549
    Turn the front turn signal light bulb socket with the front turn signal light bulb in the direction indicated by the arrow to connect them as a unit.


9. INSTALL NO. 2 HEADLIGHT BULB

  1. E282547
    Turn the No. 2 headlight bulb in the direction indicated by the arrow to install it.

    NOTICE:
    Do not touch the glass part of the bulb.

  1. Connect the connector.

← ADJUSTMENT (from Aug 2013)INSTALLATION (from Aug 2013) →