Radio Receiver Power Source Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit provides power to the radio and display receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the radio and display receiver assembly connectors.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H49-7 (GND1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
H49-4 (+B1) - Body ground
Always
11 to 14 V
H49-3 (ACC1) - Body ground
Engine switch on (ACC)
11 to 14 V
H51-1 (IG) - Body ground
Engine switch on (IG)
11 to 14 V
| *a |
Front view of wire harness connector (to Radio and Display Receiver Assembly) |
|
|
||||
| OK | ||
| ||
