2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Bench Seat Type)

  1. B295930
    Pass the front seat inner belt assembly RH through the band of the front seat cushion cover as shown in the illustration.

  1. B294015E01
    Install the front seat inner belt assembly RH to the front seat assembly RH with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Make sure that the protruding part of the front seat inner belt assembly RH is not positioned on top of the frame.

    Text in Illustration 
    *a
    Protruding Part

  1. Attach the 3 wire harness clamps and connect the occupant detection sensor connector.

  1. Install the front seat assembly RH (Click here).


2. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

  1. B241692E01
    Install the front seat inner belt assembly LH to the front seat assembly LH with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly LH to overlap the protruding parts of the front seat adjuster.

    Text in Illustration 
    *a
    Protruding Part

  1. Connect the connector and attach the 4 clamps.


3. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Passenger Side)
  1. Install the front seat inner belt assembly RH to the front seat assembly RH with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly RH to overlap the protruding parts of the front seat adjuster.

  1. for Manual Seat, Power Seat 4 Way Seat Type:
    Connect the 2 connectors and attach the 3 clamps.

  1. for Power Seat 8 Way Seat Type:
    Connect the 2 connectors and attach the 6 clamps.


4. INSTALL FRONT SEAT ASSEMBLY LH
  1. for Manual Seat:
    Install the front seat assembly LH (Click here).

  1. for Power Seat:
    Install the front seat assembly LH (Click here).

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2014) →