2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR

A245478E01

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    Text in Illustration 
    *1
    Blue Tape

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The identification tape on the exhaust gas temperature sensor is blue.

  1. Attach the No. 3 exhaust gas temperature sensor wire harness.


2. INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR

A245477E01

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    Text in Illustration 
    *A
    for Automatic Transmission
    *B
    for Manual Transmission
    *1
    Yellow Tape
    *2
    Red Tape

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    Refer to the illustration to identify the No. 2 exhaust gas temperature sensor being used.


3. INSTALL EXHAUST GAS TEMPERATURE SENSOR

A245476E01

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    Text in Illustration 
    *1
    Green Tape

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The identification tape on the exhaust gas temperature sensor is green.


4. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)
← INSPECTION (from Aug 2013)INSPECTION (from Aug 2013) →