2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts and No. 1 engine under cover.


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. A218364
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug.

    A245857E01

    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Vent Plug
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Drain Cock Plug


4. REMOVE TURBINE OUTLET ELBOW
(Click here)

5. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

  1. A245473E01
    Remove the 2 bolts and injector holder.
    Text in Illustration 
    *1
    Injector Holder
    *2
    No. 1 Nozzle Holder Clamp
    *3
    Exhaust Fuel Addition Injector
    *4
    E-Ring
    *5
    No. 3 Backup Ring
    *6
    O-Ring
    *7
    No. 2 Backup Ring
    *8
    No. 1 Backup Ring
    *9
    Gasket

  1. Using a T40 "TORX" socket wrench, remove the screw, washer and No. 1 nozzle holder clamp.

  1. Remove the exhaust fuel addition injector and gasket.

  1. Remove the E-ring, O-ring and 3 backup rings from the exhaust fuel addition injector.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →