2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL RAIN SENSOR TAPE

NOTICE:
The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

  1. Clean the rain sensor sensing portion with a piece of cloth, etc.

  1. E179754E01
    Peel off the smaller release sheet, and then attach the rain sensor tape on the rain sensor sensing portion as shown in the illustration.

    Standard:
    Area
    Measurement
    A
    13.5 mm (0.532 in.)
    B
    7.5 mm (0.295 in.)

    Text in Illustration 
    *1
    Rain Sensor Tape

    NOTICE:
    Use your fingers to push out any air bubbles from under the tape.


2. INSTALL RAIN SENSOR
  1. Clean the windshield glass with a piece of cloth, etc.

    NOTICE:
    1. Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.
    2. If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

  1. When installing a new rain sensor or replacing the rain sensor tape:

    1. Peel off the release sheet.

      HINT:
      Do not touch the silicon coated surfaces.

    2. E182986E02
      Attach the 2 guides, and then carefully install the rain sensor to the glass surface so that there are no air bubbles from forming between the contact surfaces.
      Text in Illustration 
      *1
      Stopper
      *2
      Guide

      NOTICE:
      Do not touch the silicon coated or glass surfaces.

    3. Push in the stopper.

    4. Connect the connector.


3. INSTALL RAIN SENSOR COVER
  1. Attach the 2 claws to install the rain sensor cover.

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →