2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE NO. 1 RAIN SENSOR COVER

  1. E197772
    Detach the 2 claws and remove the rain sensor cover.


2. REMOVE RAIN SENSOR

  1. E197773
    Disconnect the connector.

  1. E179753E02
    Release the stopper by pulling it down.
    Text in Illustration 
    *1
    Stopper

  1. Remove the rain sensor as shown in the illustration.


3. CLEAN WINDSHIELD GLASS

NOTICE:
  1. The rain sensor tape can be reused, however, replace it with a new piece of tape if it is dirty or damaged.
  2. Check that the rain sensor tape does not remain on the windshield glass. If it does, remove it before installing the rain sensor.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →