DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| PARKING ASSIST MONITOR DIAGNOSIS SYSTEM |
In diagnostic mode for the parking assist monitor system, signals received by the navigation receiver assembly can be checked and the parking assist monitor system can be calibrated, adjusted and checked using the multi-display.
- NOTICE:
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- HINT:
- The displayed items may differ depending on vehicle specifications.
| DIAGNOSIS SCREEN TRANSITION |
During parking assist monitor system initialization




After parking assist monitor system initialization




| VEHICLE SIGNAL CHECK |
- HINT:
- Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.
Start diagnostic mode (Click here).
Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/ Setting I" screen.

Select "Vehicle Signal" on the "Function Check/ Setting I" screen.

Vehicle Signal Check Mode

When the "Vehicle Signal Check Mode" screen is displayed, check "REV" the vehicle signal conditions.
- HINT:
- Only conditions having inputs are displayed.
- This screen displays vehicle signals input to the navigation receiver assembly.
- Only conditions having inputs are displayed.
Finish diagnostic mode (Click here).
| CAR SIGNAL CHECK (parking assist monitor system input signals) |
Start diagnostic mode (Click here).
Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/ Setting I" screen.

Select "Camera Setting" on the "Function Check/Setting I" screen.

Select "Next" on the "Car Information Check" screen.

- HINT:
- After "Next" is selected, the screen transitions differ depending on whether initialization of the parking assist monitor system was performed after the navigation receiver assembly was replaced.
Parking Assist Monitor System Initialization
Screen Transition
Not performed
Car Signal Check screen
Performed
Mode Setting screen
When the screen changes to the "Mode Setting screen", select "Back Camera Setting" to display the "Car Signal Check" screen.

- HINT:
- To select a grayed out item, select and hold the item for 2 seconds or more.
Car Signal Check

On the "Car Signal Check" screen, it is possible to inspect the state of signals and check the settings.
Item
Inspection Detail
Note
BCTY
Back door courtesy switch signal input
When "CHK" (red) is displayed, selecting "Next" will not change to the next screen.
- HINT:
- When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.
- If performing the adjustment after proceeding to the next screen, confirm that all items display "OK" (blue) before selecting "Next".
- When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.
BCTY inspection
- HINT:
- If "CHK" (red) is displayed for "BCTY", check for DTCs and perform troubleshooting based on the output DTCs (Click here).
Finish diagnostic mode (Click here).
| CALIBRATION WHEN SERVICING VEHICLE |
- NOTICE:
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).