2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


PARKING ASSIST MONITOR DIAGNOSIS SYSTEM
  1. In diagnostic mode for the parking assist monitor system, signals received by the navigation receiver assembly can be checked and the parking assist monitor system can be calibrated, adjusted and checked using the multi-display.

    NOTICE:
    Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

    HINT:
    The displayed items may differ depending on vehicle specifications.


DIAGNOSIS SCREEN TRANSITION

  1. During parking assist monitor system initialization
    E283800E01
    E276135

  2. After parking assist monitor system initialization
    E283801E01
    E276136


VEHICLE SIGNAL CHECK

HINT:
Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.

  1. Start diagnostic mode (Click here).

  2. E271944
    Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/ Setting I" screen.

  3. E271945
    Select "Vehicle Signal" on the "Function Check/ Setting I" screen.

  4. E225776
    Vehicle Signal Check Mode

    1. When the "Vehicle Signal Check Mode" screen is displayed, check "REV" the vehicle signal conditions.

      HINT:
      1. Only conditions having inputs are displayed.
      2. This screen displays vehicle signals input to the navigation receiver assembly.

  5. Finish diagnostic mode (Click here).


CAR SIGNAL CHECK (parking assist monitor system input signals)

  1. Start diagnostic mode (Click here).

    1. E271944
      Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/ Setting I" screen.

    2. E271945
      Select "Camera Setting" on the "Function Check/Setting I" screen.

    3. E283802
      Select "Next" on the "Car Information Check" screen.

      HINT:
      After "Next" is selected, the screen transitions differ depending on whether initialization of the parking assist monitor system was performed after the navigation receiver assembly was replaced.
      Parking Assist Monitor System Initialization
      Screen Transition
      Not performed
      Car Signal Check screen
      Performed
      Mode Setting screen

    4. E276139
      When the screen changes to the "Mode Setting screen", select "Back Camera Setting" to display the "Car Signal Check" screen.

      HINT:
      To select a grayed out item, select and hold the item for 2 seconds or more.

  2. E276130
    Car Signal Check

    1. On the "Car Signal Check" screen, it is possible to inspect the state of signals and check the settings.

      Item
      Inspection Detail
      Note
      BCTY
      Back door courtesy switch signal input
      When "CHK" (red) is displayed, selecting "Next" will not change to the next screen.

      HINT:
      1. When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.
      2. If performing the adjustment after proceeding to the next screen, confirm that all items display "OK" (blue) before selecting "Next".

  3. BCTY inspection

    HINT:
    If "CHK" (red) is displayed for "BCTY", check for DTCs and perform troubleshooting based on the output DTCs (Click here).

  4. Finish diagnostic mode (Click here).


CALIBRATION WHEN SERVICING VEHICLE

NOTICE:
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

← TERMINALS OF ECU (from Aug 2013)DIAGNOSIS SYSTEM (from Aug 2014) →