U0100 Lost Communication with ECM
Diagnostic trouble codes · Vehicles built from Aug 2014
Also covers:
- U0126 Lost Communication with Steering Angle Sensor Module
- U0129 VSC(ECB)ECU Communication
- U0140 Lost Communication with Body Control Module
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
These DTCs are stored if there is a malfunction in the CAN communication system connected to the navigation receiver assembly.- HINT:
- If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0100 |
Lost Communication with ECM |
CAN communication system |
| U0126 |
Lost communication with spiral with sensor cable sub-assembly |
|
| U0129 |
Lost communication with skid control ECU (brake actuator assembly) |
|
| U0140 |
Lost communication with body control module (multiplex network body ECU) |
INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- Result:
Result
Proceed to
DTCs are output
A
No DTCs are output
B
- HINT:
- If CAN communication system DTCs are stored, they may also be stored in other systems.
- If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
- If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click here).
- If CAN communication system DTCs are stored, they may also be stored in other systems.
|
|
||||
| A | ||
| ||
