2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

U0100 Lost Communication with ECM

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the navigation receiver assembly.

HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.

DTC No.
DTC Detection Condition
Trouble Area
U0100
Lost Communication with ECM
CAN communication system
U0126
Lost communication with spiral with sensor cable sub-assembly
U0129
Lost communication with skid control ECU (brake actuator assembly)
U0140
Lost communication with body control module (multiplex network body ECU)

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTCs are output
    A
    No DTCs are output
    B

HINT:
  1. If CAN communication system DTCs are stored, they may also be stored in other systems.
  2. If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
  3. If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click here).



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)


← C1694 Steering Angle Initialization Incomplete (from Aug 2014)U0100 Lost Communication with ECM (+ U0126, U0129, U0140) (from Aug 2014) →