2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE BACK DOOR CENTER GARNISH

  1. B239438
    Detach the 4 clips and remove the back door center garnish.


2. REMOVE BACK DOOR SIDE GARNISH LH

  1. B239439
    Detach the 2 clips and claw and remove the back door side garnish.


3. REMOVE BACK DOOR SIDE GARNISH RH

  1. B239440
    Detach the 2 clips and claw and remove the back door side garnish.


4. REMOVE BACK DOOR TRIM COVER

  1. B239441
    Remove the back door trim cover as shown in the illustration.


5. REMOVE UPPER TOOL BOX PANEL SUB-ASSEMBLY

  1. B239442
    Remove the upper tool box panel sub-assembly as shown in the illustration.


6. REMOVE TOOL CASE

  1. B239445
    Detach the 2 claws and remove the tool case.


7. REMOVE BACK DOOR LOCK COVER (w/o Back Door Tire Carrier)

  1. B239443
    Using moulding remover B, detach the clip and 6 claws and remove the back door lock cover.


8. REMOVE BACK DOOR INSIDE HANDLE BEZEL (for Face to Face Seat Type)

  1. B239466
    Remove the screw.

  1. Detach the 5 claws and remove the back door inside handle bezel.


9. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

  1. B241516
    Detach the claw and remove the cover.

    HINT:
    Tape the screwdriver tip before use.

  1. B239444
    Remove the screw.

  1. w/o Back Door Tire Carrier:

    1. B239446
      Remove the bolt.

    2. Detach the 15 clips and remove the back door trim panel assembly.

  1. w/ Back Door Tire Carrier:

    1. B239447
      Remove the bolt.

    2. Detach the 16 clips and remove the back door trim panel assembly.

  1. for Face to Face Seat Type:

    1. B241528
      Remove the screw and bolt.

    2. Detach the 15 clips and remove the back door trim panel assembly.


10. REMOVE RADIO SETTING CONDENSER

NOTICE:
If it is necessary to replace the radio setting condenser or terminal cover, both parts must be replaced as they are supplied as a set.

  1. B240498E01
    Using a screwdriver, detach the 8 claws and remove the terminal cover with wire harness from the condenser.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. B240499
    Remove the bolt.

  1. Detach the clamp from the vehicle body and remove the condenser.

← ON-VEHICLE INSPECTION (from Aug 2013)INSPECTION (from Aug 2013) →