Reverse Signal Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The blind spot monitor sensor RH receives a reverse signal from the back-up light switch assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY |
 |
Remove the back-up light switch assembly (Click here).
Inspect the back-up light switch assembly (Click here).
|
NG |
 |
|
| REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)
|
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH ASSEMBLY - BATTERY) |
 |
- Disconnect the back-up light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
C41-2 - Body ground
|
Engine switch on (IG)
|
11 to 14 V
|
Engine switch off
|
Below 1 V
|
Text in Illustration
*a
|
Front view of wire harness connector (to Back-up Light Switch Assembly)
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BACK-UP LIGHT SWITCH ASSEMBLY) |
 |
Disconnect the R43 blind spot monitor sensor RH connector.
Disconnect the C41 back-up light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
R43-8 (SPR) - C41-1
|
Always
|
Below 1 Ω
|
R43-8 (SPR) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|