2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Reverse Signal Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The blind spot monitor sensor RH receives a reverse signal from the back-up light switch assembly.

WIRING DIAGRAM

E280619E14

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
  1. Remove the back-up light switch assembly (Click here).

  1. Inspect the back-up light switch assembly (Click here).



NG
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH ASSEMBLY - BATTERY)

  1. E195965E07
    Disconnect the back-up light switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    C41-2 - Body ground
    Engine switch on (IG)
    11 to 14 V
    Engine switch off
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Back-up Light Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BACK-UP LIGHT SWITCH ASSEMBLY)
  1. Disconnect the R43 blind spot monitor sensor RH connector.

  1. Disconnect the C41 back-up light switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R43-8 (SPR) - C41-1
    Always
    Below 1 Ω
    R43-8 (SPR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← U1331 Software Incompatibility with Body Control Module "B" (from Aug 2014)Reverse Signal Circuit (from Aug 2014) →