2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE ROOF HEADLINING ASSEMBLY
  1. for 5 Door:

    1. Remove the roof headlining assembly (Click here).

  1. for 3 Door:

    1. Remove the roof headlining assembly (Click here).


2. REMOVE NO. 2 AIR DUCT REAR SIDE (w/ Rear Cooler)

  1. B236601
    Detach the 2 clips.

  1. Detach the clamp and remove the duct.


3. REMOVE NO. 1 AIR DUCT REAR SIDE (w/ Rear Cooler)

  1. B236603
    Detach the 2 claws and remove the cooler plate.

  1. B236604
    Swing the bottom of the duct sideways and remove the duct.


4. REMOVE REAR NO. 2 SIDE RAIL SPACER LH (for 3 Door)

B240546
  1. Remove the clip.

  1. Detach the 4 claws and remove the rear side rail spacer.


5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/o Rear No. 2 Seat)
  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the 13 bolts and curtain shield airbag.

    B238348


6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Rear No. 2 Seat)
  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the 17 bolts and curtain shield airbag.

    B238349


7. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (for 3 Door)

  1. B238347
    Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the 11 bolts and curtain shield airbag.

    B238350

← ON-VEHICLE INSPECTION (from Aug 2014)REMOVAL (from Aug 2014) →