REMOVAL
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE ROOF HEADLINING ASSEMBLY |
for 5 Door:
Remove the roof headlining assembly (Click here).
for 3 Door:
Remove the roof headlining assembly (Click here).
| 2. REMOVE NO. 2 AIR DUCT REAR SIDE (w/ Rear Cooler) |
Detach the 2 clips.

Detach the clamp and remove the duct.
| 3. REMOVE NO. 1 AIR DUCT REAR SIDE (w/ Rear Cooler) |
Detach the 2 claws and remove the cooler plate.

Swing the bottom of the duct sideways and remove the duct.

| 4. REMOVE REAR NO. 2 SIDE RAIL SPACER LH (for 3 Door) |
![]() ![]() |
Remove the clip.
Detach the 4 claws and remove the rear side rail spacer.
| 5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/o Rear No. 2 Seat) |
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the 13 bolts and curtain shield airbag.


| 6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Rear No. 2 Seat) |
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the 17 bolts and curtain shield airbag.


| 7. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (for 3 Door) |
Disconnect the connector.

- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the 11 bolts and curtain shield airbag.



