2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for LHD and RHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH side and LH side.
  4. The procedure listed below is for the LH side.


1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Install the side airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that the side airbag sensor is not loose.

  1. Connect the connector.


2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

  1. B238605
    Install the front door inner glass weatherstrip.


3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B241244
    Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

  1. Connect 2 connectors.

  1. w/ Seat Position Memory System:

    1. Connect the connectors.

  1. B241251
    Attach the front door trim board sub-assembly by attaching the 4 claws of the front door inner glass weatherstrip as shown in the illustration.

  1. B238522
    Attach the 12 clips and front door trim board retainer to install the front door trim board sub-assembly.

  1. Install the 3 screws.


4. INSTALL ASSIST GRIP COVER LH

  1. B241252
    Attach the 8 claws to install the assist grip cover.


5. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

  1. B241259
    Attach the 3 claws to install the inside handle bezel.


6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
  1. Attach the 2 claws to install the front door lower frame bracket garnish.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


8. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).

← INSTALLATION (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →