2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for LHD and RHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH side and LH side.
  4. The procedure listed below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here)
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  1. B240614
    Detach the 2 clips and remove the front door lower frame bracket garnish LH.


3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

  1. B238520
    Using a moulding remover, detach the 3 claws and remove the inside handle bezel as shown in the illustration.


4. REMOVE ASSIST GRIP COVER LH

  1. B238521
    Using moulding remover A, detach the 8 claws and remove the assist grip cover.


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B238522
    Remove the 3 screws.

  1. Remove the 12 clips.

  1. B238523E01
    Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.
    Text in Illustration 
    *1
    Reference Boss

  1. Raise the front door trim board sub-assembly to detach the 4 claws and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip LH.

  1. B238524
    Disconnect the 2 connectors.

  1. w/ Seat Position Memory System:

    1. B240206
      Disconnect the connectors.

  1. B238525
    Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.


6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

  1. B238526
    Using a screwdriver, detach the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.


7. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH

  1. B238362
    Disconnect the connector.

  1. Remove the bolt and side airbag sensor.

← REMOVAL (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →