Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
2.
REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION
HINT:
Use the same procedure described for the No. 2 instrument panel finish panel cushion.
3.
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Detach the 4 clips and remove the instrument panel finish panel end RH.