2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here)
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

HINT:
Use the same procedure described for the No. 2 instrument panel finish panel cushion.


3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

B356217
  1. Detach the 4 clips and remove the instrument panel finish panel end RH.


4. REMOVE TELLTALE LIGHT ASSEMBLY

  1. B241149
    Remove the 2 screws and light.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →