2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2074 Driver Side Seat Belt Buckle Switch Circuit Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The seat belt control ECU receives driver side buckle switch condition information from the center airbag sensor assembly through the CAN communication line and controls the pre-crash safety system.
This code is stored when a buckle switch malfunction signal is received from the airbag system.
When DTC B2074 is stored, DTC B1655/37 is also stored.
DTC Code
DTC Detection Condition
Trouble Area
B2074
While the initial check is running, the ignition switch is ON and the pre-crash safety system is operating, malfunction a signal is received from the center airbag sensor for 3 seconds.
  1. Airbag system
  2. Seat belt control ECU

INSPECTION PROCEDURE


1. CHECK FOR DTC (AIRBAG SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    DTC B1655/37 is not output.



NG
GO TO AIRBAG SYSTEM (Click here)
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2074 is not output.



NG
REPLACE SEAT BELT CONTROL ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← B2064 Vehicle Type Signal Malfunction (from Aug 2014)B2074 Driver Side Seat Belt Buckle Switch Circuit Malfunction (from Aug 2014) →