B2075 Passenger Side Seat Belt Buckle Switch Circuit Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when there is a malfunction in the front seat inner belt buckle switch circuit for the passenger side. The seat belt control ECU receives buckle switch condition information from the front seat inner belt and controls the pre-crash safety system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2075 |
A malfunction in the front seat inner belt (buckle switch) circuit. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B2075 is not output.
|
|
||||
| OK | ||
| ||
| 2. CHECK SEAT BELT CONTROL ECU |
Remove the seat belt control ECU, but do not disconnect the connector (Click here).


Using an oscilloscope, check the waveform.
Measurement Condition Item
Content
Tester Connection
G118-5 (PBK+) - G118-6 (PBK-)
Tool Setting
2 V/DIV., 20 ms/DIV.
Condition
Ignition switch ON, front seat belt (for passenger side) fastened → unfastened
- OK:
- Waveform is as shown in illustration.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (SEAT BELT CONTROL ECU - FRONT SEAT INNER BELT ASSEMBLY) |
Disconnect the G118 ECU connector.
Disconnect the Q21*1 or R34*2 belt connector.
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection
Condition
Specified Condition
G118-5 (PBK+) - Q21-5 (RBE+)
Always
Below 1 Ω
G118-6 (PBK-) - Q21-4 (RBE-)
G118-5 (PBK+) - Body ground
Always
10 kΩ or higher
G118-6 (PBK-) - Body ground
for RHD Tester Connection
Condition
Specified Condition
G118-5 (PBK+) - R34-5 (LBE+)
Always
Below 1 Ω
G118-6 (PBK-) - R34-4 (LBE-)
G118-5 (PBK+) - Body ground
Always
10 kΩ or higher
G118-6 (PBK-) - Body ground
|
|
||||
| OK | ||
| ||
