2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2075 Passenger Side Seat Belt Buckle Switch Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when there is a malfunction in the front seat inner belt buckle switch circuit for the passenger side. The seat belt control ECU receives buckle switch condition information from the front seat inner belt and controls the pre-crash safety system.
DTC Code
DTC Detection Condition
Trouble Area
B2075
A malfunction in the front seat inner belt (buckle switch) circuit.
  1. Front seat inner belt assembly (for passenger side)
  2. Harness or connector
  3. Seat belt control ECU

WIRING DIAGRAM

E200777E01

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

OK:
DTC B2075 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK SEAT BELT CONTROL ECU

  1. Remove the seat belt control ECU, but do not disconnect the connector (Click here).E200101E02

  1. Using an oscilloscope, check the waveform.

    Measurement Condition 
    Item
    Content
    Tester Connection
    G118-5 (PBK+) - G118-6 (PBK-)
    Tool Setting
    2 V/DIV., 20 ms/DIV.
    Condition
    Ignition switch ON, front seat belt (for passenger side) fastened → unfastened

    OK:
    Waveform is as shown in illustration.



NG
Go to step 3
OK

REPLACE SEAT BELT CONTROL ECU (Click here)

3. CHECK HARNESS AND CONNECTOR (SEAT BELT CONTROL ECU - FRONT SEAT INNER BELT ASSEMBLY)
  1. Disconnect the G118 ECU connector.

  1. Disconnect the Q21*1 or R34*2 belt connector.

    1. *1: for LHD
    2. *2: for RHD

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    G118-5 (PBK+) - Q21-5 (RBE+)
    Always
    Below 1 Ω
    G118-6 (PBK-) - Q21-4 (RBE-)
    G118-5 (PBK+) - Body ground
    Always
    10 kΩ or higher
    G118-6 (PBK-) - Body ground
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    G118-5 (PBK+) - R34-5 (LBE+)
    Always
    Below 1 Ω
    G118-6 (PBK-) - R34-4 (LBE-)
    G118-5 (PBK+) - Body ground
    Always
    10 kΩ or higher
    G118-6 (PBK-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT SEAT INNER BELT ASSEMBLY (for Passenger Side) (Click here)


← B2075 Passenger Side Seat Belt Buckle Switch Circuit Malfunction (Aug 2013 – Jul 2014)B2085 Communication Error from Driving Support ECU to VSC ECU (Aug 2013 – Jul 2014) →