2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

C1A10 Front Radar Sensor

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

The driving support ECU uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.
Based on this information, the driving support ECU sends pre-crash control operation signals.
When the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.
DTC Code
DTC Detection Condition
Trouble Area
C1A10
While the ignition switch ON, the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor for 1 second.
  1. Millimeter waver radar sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE


1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
  1. Replace the millimeter wave radar sensor assembly (Click here).


NEXT


2. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
  1. Adjust the millimeter wave radar sensor assembly (Click here).


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1A10 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY IS DEFECTIVE)


← C1A0A Front Radar Sensor Region Code Mismatch (from Aug 2013)C1A11 Front Radar Sensor Incorrect Axial Gap (+ C1A14) (from Aug 2013) →