2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

C1A46 Yaw Rate Sensor

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

The skid control ECU receives vehicle stability signals from the yaw rate sensor and sends the signals to the driving support ECU and ECM. If the skid control ECU detects that the yaw rate sensor is malfunctioning, the skid control ECU and yaw rate sensor send a malfunction signal to the driving support ECU which stores DTC C1A46.
DTC Code
DTC Detection Condition
Trouble Area
C1A46
While the vehicle speed is 5 km/h (3 mph) or more, a malfunction signal from the skid control ECU and yaw rate sensor is detected for 1 second.
  1. Vehicle stability control system
  2. Driving support ECU

INSPECTION PROCEDURE


1. CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    Vehicle stability control system DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1A46 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← C1A11 Front Radar Sensor Incorrect Axial Gap (+ C1A14) (from Aug 2013)C1A47 Steering Angle Sensor (from Aug 2013) →