2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

U0122 Lost Communication with Vehicle Dynamics Control Module

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

These DTCs are stored when a communication malfunction occurs between the sensors and ECUs that detect collisions, or between ECUs that perform pre-crash control.
DTC Code
DTC Detection Condition
Trouble Area
U0122
While the ignition switch is ON, communication stops between the skid control ECU and driving support ECU or seat belt control ECU for 1 second or more.
  1. Master cylinder solenoid (Skid control ECU)
  2. CAN communication system
  3. Seat belt control ECU
  4. Driving support ECU
U0123
While the ignition switch is ON, communication stops between the yaw rate sensor and driving support ECU for 1 second or more.
  1. Yaw rate sensor
  2. CAN communication system
  3. Driving support ECU
U0126
While the ignition switch is ON, communication stops between the steering angle sensor and driving support ECU for 1 second or more.
  1. Steering angle sensor
  2. CAN communication system
  3. Driving support ECU
U0140
While the ignition switch is ON, communication stops between the main body ECU and seat belt control ECU for 1 second or more.
  1. Main body ECU (Multiplex network body ECU)
  2. CAN communication system
  3. Seat belt control ECU
U0151
While the ignition switch is ON, communication stops between the center airbag sensor assembly and seat belt control ECU for 1 second or more.
  1. Center airbag sensor assembly
  2. CAN communication system
  3. Seat belt control ECU
U1100
While the ignition switch is ON, communication stops between the seat belt control ECU and driving support ECU for 1 second or more.
  1. Seat belt control ECU
  2. CAN communication system
  3. Driving support ECU

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Select "Bus Check" from the "System Select" screen on the intelligent tester.

  1. Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output (for LHD with Entry and Start System)
    B
    CAN DTC is output (for LHD without Entry and Start System)
    C
    CAN DTC is output (for RHD with Entry and Start System)
    D
    CAN DTC is output (for RHD without Entry and Start System)
    E



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← U0122 Lost Communication with Vehicle Dynamics Control Module (+ 5 more codes) (Aug 2013 – Jul 2014)U0235 Lost Communication with Cruise Control Front Distance Range Sensor (Aug 2013 – Jul 2014) →