2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CAMSHAFT
  1. Inspect the circle runout.

    1. Place the camshaft on V-blocks.

    2. Using a dial indicator, measure the circle runout at the center journal.

      Maximum circle runout:
      0.10 mm (0.00394 in.)

      If the circle runout is more than the maximum, replace the camshaft.

  1. Using a micrometer, measure the cam lobe height.

    Standard Cam Lobe Height:
    Cam Lobe
    Specified Condition
    Intake
    54.890 to 54.910 mm (2.1610 to 2.1618 in.)
    Exhaust
    54.990 to 55.010 mm (2.1650 to 2.1657 in.)

    Minimum Cam Lobe Height:
    cam Lobe
    Specified Condition
    Intake
    54.39 mm (2.141 in.)
    Exhaust
    54.49 mm (2.145 in.)

    If the cam lobe height is less than the minimum, replace the camshaft.


INSPECT INTAKE MANIFOLD

A121633
  1. Using a precision straightedge and feeler gauge, measure the surface that contact the cylinder head for warpage.

    Maximum warpage:
    0.40 mm (0.0157 in.)

    If the warpage is more than the maximum, replace the intake manifold.


INSPECT EXHAUST MANIFOLD

A121634
  1. Using a precision straightedge and feeler gauge, measure the surface that contact the cylinder head for warpage.

    Maximum warpage:
    0.40 mm (0.0157 in.)

    If the warpage is more than the maximum, replace the exhaust manifold.


INSPECT CYLINDER HEAD SET BOLT

  1. A057442E05
    Using a vernier caliper, measure the minimum outer diameter of the elongated thread at the measuring point.

    Standard outer diameter:
    11.80 to 12.00 mm (0.465 to 0.472 in.)

    Minimum outer diameter:
    11.60 mm (0.457 in.)

    Text in Illustration 
    *a
    Measuring Point
    *b
    Elongated Thread
    If the diameter is less than the minimum, replace the cylinder head set bolt.

← DISASSEMBLY (from Aug 2013)REASSEMBLY (from Aug 2013) →