2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Clearance Sonar Main Switch Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the back sonar or clearance sonar switch assembly is turned on, the on signal is input into the ECU.

WIRING DIAGRAM

E194320E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

  1. E194321E01
    Remove the back sonar or clearance sonar switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (ECU) - 6 (IG)
    Pressed (on)
    Below 1 Ω
    3 (ECU) - 6 (IG)
    Not pressed (off)
    10 kΩ or higher



NG
REPLACE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (BACK SONAR OR CLEARANCE SONAR SWITCH - BATTERY AND BODY GROUND)

  1. B154299E07
    Disconnect the G13 back sonar or clearance sonar switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G13-6 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    G13-6 (IG) - Body ground
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G13-7 (IND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Back Sonar or Clearance Sonar Switch)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (BACK SONAR OR CLEARANCE SONAR SWITCH - CLEARANCE WARNING ECU)
  1. Disconnect the G13 back sonar or clearance sonar switch assembly connector.

  1. Disconnect the I1 clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G13-3 (ECU) - I1-8 (CSSW)
    Always
    Below 1 Ω
    G13-3 (ECU) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Sonar Main Switch Circuit (Aug 2013 – Jul 2014)Clearance Warning Buzzer Circuit (Aug 2013 – Jul 2014) →