2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Idle Up Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the idle up switch is pushed, the air conditioning amplifier assembly outputs the engine idle up signal. If engine idle up does not occur when the idle up switch is pushed, there may be a problem in the circuit shown below.

WIRING DIAGRAM

E196912E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (IDLE UP SWITCH)
  1. Use the Data List to check if the idle up switch is functioning properly (Click here).

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IDLE UP/PWR HEAT Switch
    Idle up switch / ON or OFF
    ON: Idle up switch on
    OFF: Idle up switch off
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT IDLE UP SWITCH

  1. E196913E01
    Remove the idle up switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (SW) - 3 (E)
    Idle up switch on
    Below 1 Ω
    6 (SW) - 3 (E)
    Idle up switch off
    10 kΩ or higher



NG
REPLACE IDLE UP SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (IDLE UP SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND)
  1. Disconnect the G20 switch connector.

  1. Disconnect the G25 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G20-6 (SW) - G25-36 (SWVC)
    Always
    Below 1 Ω
    G20-3 (E) - Body ground
    Always
    Below 1 Ω
    G25-36 (SWVC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← Air Conditioning Control Panel Circuit (from Aug 2014)Idle Up Switch Circuit (from Aug 2014) →