OPERATION CHECK
Troubleshooting · Vehicles built from Aug 2013
| INPUT SIGNAL CHECK |
![]() ![]() |
Connect the intelligent tester to the DLC3.
Check the cruise control switch (ON-OFF, CANCEL, -SET, +RES and MODE) using the Data List function in the intelligent tester.
| INSPECT MODE SWITCH |
![]() ![]() |
Turn the ignition switch to ON.
Turn the cruise control switch on.
Push the cruise control switch to MODE for 1 second or more to change to constant speed control mode. Check that the multi-information display changes from displaying "RADAR READY" to a black screen.

Check that the cruise control indicator light (vehicle-to-vehicle distance control mode) turns off and the CRUISE main indicator light (constant speed control mode) turns on.
Text in Illustration *1
Multi-information Display
*2
Cruise Control Indicator Light (Vehicle-to-vehicle Distance Control Mode)
*3
Cruise Control Indicator Light (Constant Speed Control Mode)
- NOTICE:
- Do not push any other switches before pushing the cruise control switch to MODE. If another switch is pushed, turn the cruise control switch off and repeat the procedure above.
- HINT:
- If a malfunction is detected, turn the ignition switch off and repeat the procedure above.
| INSPECT STEERING PAD SWITCH ASSEMBLY |
Turn the ignition switch to ON.
Turn the cruise control switch on. Check that "RADAR READY" is indicated on the multi-information display and that the cruise control indicator light turns on.
Push the distance control switch of the steering pad switch assembly.
Check that the indication of the vehicle-to-vehicle distance, which is shown in the multi-information display in the combination meter assembly, changes from long to middle to short in that order.


Text in Illustration *1
Steering Pad Switch Assembly (Distance Control Switch)
*2
Multi-information Display
*3
Long
*4
Middle
*5
Short
-
-
- HINT:
- The indication is automatically set to long each time the engine is started.

