REPLACEMENT
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge the fuel system pressure (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 3. DISCONNECT FUEL HOSE |
Disconnect the hose from the clamp.
Disconnect the fuel hose (Click here).

| 4. DISCONNECT FUEL MAIN TUBE |
Disconnect the fuel main tube (Click here).

| 5. REMOVE FUEL FILTER ASSEMBLY |
Remove the 3 bolts and fuel filter.

| 6. INSTALL FUEL FILTER ASSEMBLY |
Install the fuel filter with the 3 bolts.
- Torque:
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
| 7. CONNECT FUEL MAIN TUBE |
Connect the fuel main tube (Click here).
| 8. CONNECT FUEL HOSE |
Connect the fuel hose (Click here).
Connect the hose to the clamp.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 10. INSPECT FOR FUEL LEAK |
Make sure that there are no fuel leaks after performing maintenance on the fuel system.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
- NOTICE:
- Do not start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no leaks from the fuel system.
If there are fuel leaks, repair or replace parts as necessary.Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.
