2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0100
While the ignition switch is ON, a communication stop between the ECM and skid control ECU or driving support ECU continues for 1 second or more.
  1. Hydraulic brake booster assembly (Skid control ECU)
  2. CAN communication system
  3. Driving support ECU
  4. ECM
U0122
While the ignition switch is ON, a communication stop between the skid control ECU and driving support ECU continues for 1 second or more.
  1. ECM
  2. CAN communication system
  3. Hydraulic brake booster assembly (Skid control ECU)
U0123
While the ignition switch is ON, a communication stop between the yaw rate sensor and driving support ECU continues for 1 second or more.
  1. Yaw rate sensor
  2. CAN communication system
  3. ECM
U0126
While the ignition switch is ON, a communication stop between the steering angle sensor and driving support ECU continues for 1 second or more.
  1. Steering angle sensor
  2. CAN communication system
  3. ECM
U1104
While the ignition switch is ON, a communication stop between the driving support ECU and ECM continues for 1 second or more.
  1. ECM
  2. CAN communication system
  3. Driving support ECU

INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.


1. CHECK CAN COMMUNICATION SYSTEM
  1. Select "Bus Check" from the "System Select" screen on the intelligent tester.

  1. Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output (for LHD with Entry and Start System)
    B
    CAN DTC is output (for LHD without Entry and Start System)
    C
    CAN DTC is output (for RHD with Entry and Start System)
    D
    CAN DTC is output (for RHD without Entry and Start System)
    E



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← P1631 Communication Error from ECM to VSC (from Aug 2013)U0100 Lost Communication with ECM / PCM "A" (+ U0122, U0123, U0126, U1104) (from Aug 2014) →