2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

P1631 Communication Error from ECM to VSC

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the skid control ECU detects a communication error from the ECM, it sends a malfunction signal back to the ECM.
DTC Code
DTC Detection Condition
Trouble Area
P1631
While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, the ECM continuously receives a logical error signal from the skid control ECU for 1 second.
  1. ECM
  2. Hydraulic brake booster assembly (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When the ECM is replaced with a new one, initialization must be performed (Click here).


1. REPLACE ECM
  1. for 1GR-FE:Replace the ECM (Click here).

  1. for 1KD-FTV:Replace the ECM (Click here).


NEXT


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 50 km/h (31 mph) or more.

    2. Turn the cruise control switch on.

  1. Check for DTCs (Click here).

    OK:
    DTC P1631 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE HYDRAULIC BRAKE BOOSTER ASSEMBLY (SKID CONTROL ECU) (Click here)

C
REPLACE HYDRAULIC BRAKE BOOSTER ASSEMBLY (SKID CONTROL ECU) (Click here)
A

END (ECM IS DEFECTIVE)


← P1630 Communication Error from VSC to ECM (from Aug 2013)U0100 Lost Communication with ECM / PCM "A" (+ U0122, U0123, U0126, U1104) (Aug 2013 – Jul 2014) →