2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


CHECK GLOW PLUG
  1. Remove the No. 1 glow plug connector (Click here).

  1. A111828E05
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Glow plug terminal - Body ground
    20°C (68°F)
    Approximately 0.95 Ω

    Text in Illustration 
    *1
    Screw Grommet
    If the result is not as specified, replace the glow plug.

    NOTICE:
    1. Be careful not to damage the glow plug pipes, as this may cause an open circuit or shorten the life of the glow plugs.
    2. Do not allow oil or gasoline to contact the glow plug when cleaning it.
    3. Clean any oil on the terminal and Bakelite washer with a dry cloth.
    4. Do not apply more than 11 V to the glow plug, as this may cause an open circuit.

  1. Install the No. 1 glow plug connector (Click here).

← COMPONENTS (from Aug 2013)ON-VEHICLE INSPECTION (from Aug 2014) →