ON-VEHICLE INSPECTION
Inspection · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| CHECK GLOW PLUG |
Remove the No. 1 glow plug connector (Click here).
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
Glow plug terminal - Body ground
20°C (68°F)
Approximately 1.2 Ω
- NOTICE:
- Be careful not to damage the glow plugs, as this may cause an open circuit or shorten the life of the glow plugs.
- Do not allow oil or gasoline to contact the glow plug when cleaning it.
- Clean off any oil on the terminal and Bakelite washer with a dry cloth.
- Do not apply more than 11 V to the glow plug, as this may cause an open circuit.
- Be careful not to damage the glow plugs, as this may cause an open circuit or shorten the life of the glow plugs.
Install the No. 1 glow plug connector (Click here).
