C1453 Reservoir Level Switch Disconnected
Diagnostic trouble codes · Vehicles built from Aug 2014
Also covers:
- C1454 Reservoir Level Low
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The brake fluid level warning switch sends the appropriate signal to the skid control ECU when the brake fluid level drops.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1453 |
With the ECU terminal IG1 voltage at 10 to 14 V, an open in the brake fluid level warning switch circuit continues for 2 seconds or more. |
|
| C1454 |
The fluid level of the reservoir is below the LOW level for 40 seconds after the ignition switch is turned to ON, or for 7 seconds during pump motor operation. |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. CHECK BRAKE FLUID LEVEL |
Turn the ignition switch off.
Depress the brake pedal 40 times or more (until the pedal reaction feels light and pedal stroke becomes longer).
Check the amount of fluid in the brake reservoir.
- HINT:
- When the ignition switch is turned to ON, brake fluid is sent to the accumulator and the fluid level decreases by approximately 5 mm (0.197 in.) from the level when the ignition switch is off (normal).
- OK:
- Brake fluid level is normal.
|
|
||||
| OK | |
| 2. INSPECT BRAKE FLUID LEVEL WARNING SWITCH |
Disconnect the A42 brake fluid level warning switch connector.
Measure the resistance according to the value(s) in the table below.

- HINT:
- A float is placed inside the reservoir. Its position can be changed by increasing/decreasing the level of brake fluid.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 (GND) - 2 (LBL)
Float UP (Switch off)
1.9 to 2.1 kΩ
Float DOWN (Switch on)
Below 1 Ω
Text in Illustration *a
Component without harness connected
(Brake Fluid Level Warning Switch)
- HINT:
- If there is no problem after finishing the above check, adjust the brake fluid level to the MAX level.
Result Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE FLUID LEVEL WARNING SWITCH) |
Disconnect the A7 skid control ECU connector.
Disconnect the A42 brake fluid level warning switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A7-41 (LBL) - A42-2 (LBL)
Always
Below 1 Ω
A7-41 (LBL) - Body ground
Always
10 kΩ or higher
A42-1 (GND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine and idle it for approximately 40 seconds.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD)
B
DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
