2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Insert the transmission control cable from the vehicle outside, and attach the 3 claws of the cable retainer.

  1. Install the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the transmission control cable to the transmission control cable bracket with a new clip, and connect the cable end to the control shaft lever with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the transmission control cable support with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Turn the socket of the transmission control cable 180° counterclockwise. While holding the socket in place, push in the lock piece until the lock piece clicks twice.

    NOTICE:
    Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.


    C216621E02
    Text in Illustration 
    *1
    Stopper
    *2
    Lock Piece
    *a
    Push in
    -
    -

    HINT:
    If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

  1. Install the outer part of the transmission control cable to the shift lever retainer. Check that the socket and lock piece are positioned at original position.

    C216998E01

    Text in Illustration 
    *1
    Shift Lever Retainer
    -
    -

  1. C203381E01
    Slide the slider in the direction shown in the illustration and pull out the lock piece.
    Text in Illustration 
    *1
    Slider
    *2
    Lock Piece

  1. C204586
    Connect the end of the cable to the shift lever assembly.

    NOTICE:
    1. Make sure that the lock piece is pulled up.
    2. Push on the end of the cable all the way to the base of the pin.

  1. C204598E04
    Push the lock piece into the adjuster case and lock it.

    NOTICE:
    Make sure that the lock piece is completely locked by the slider.


2. INSTALL REAR CONSOLE BOX ASSEMBLY
  1. Install the rear console box (Click here).


3. INSTALL REAR CONSOLE BOX ASSEMBLY (w/ Refrigerated Cool Box)
  1. Install the console box (Click here).

← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →