2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A224743
    Remove the 4 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.


2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the 4 bolts and rear engine under cover.


3. REMOVE FRONT FENDER APRON SEAL RH

  1. C214927
    Remove the 5 clips and front fender apron seal RH.


4. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH

  1. C214928
    Remove the 5 clips and front No. 1 fender apron to frame seal.


5. REMOVE NO. 1 OIL COOLER INLET HOSE AND NO. 1 OIL COOLER OUTLET HOSE

C213699E01
  1. Disconnect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the No. 2 oil cooler tube.

  1. Disconnect the 2 hoses from the oil cooler inlet tube and No. 1 oil cooler outlet tube and remove them.

    NOTICE:
    When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.


6. REMOVE NO. 1 OIL COOLER INLET TUBE AND NO. 1 OIL COOLER OUTLET TUBE

C213701
  1. Using a union nut wrench, disconnect the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube from each oil cooler tube union.

  1. Remove the 3 bolts to open the 3 No. 2 flexible hose clamps and remove 2 oil cooler tubes.


7. REMOVE NO. 2 OIL COOLER INLET HOSE AND NO. 2 OIL COOLER OUTLET HOSE

C213704E01
  1. Detach the claw to open the No. 1 flexible hose clamp.

  1. Disconnect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose from the radiator.

  1. Disconnect the 2 hoses from the No. 2 oil cooler tube and remove them.

    NOTICE:
    When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.


8. REMOVE NO. 2 OIL COOLER TUBE SUB-ASSEMBLY

C214907
  1. Remove the 2 bolts and No. 2 oil cooler tube.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →