2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE NO. 1 RELAY BLOCK COVER
  1. Remove the No. 1 relay block cover.


INSPECT NO. 1 INTEGRATION RELAY

  1. B236388E01
    Using a screwdriver, detach the 2 claws and disconnect the No. 1 integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. B216347E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1A-8 - 1C-1 *A
    1H-8 - 1C-1 *B
    Battery voltage is not applied to terminals 1C-1 and 1A-7 *A
    Battery voltage is not applied to terminals 1C-1 and 1A-7*B
    10 kΩ or higher
    1A-8 - 1C-1 *A
    1H-8 - 1C-1 *B
    Battery voltage is applied to terminals 1C-1 and 1A-7 *A
    Battery voltage is applied to terminals 1C-1 and 1A-7 *B
    Below 1Ω

    *A: for Gasoline Engine
    *B: for Diesel Engine
    If the result is not as specified, replace the No. 1 integration relay.
    Text in Illustration 
    *A
    for Gasoline Engine
    *B
    for Diesel Engine
    *a
    Component with harness connected
    (No. 1 Integration Relay)

  1. Attach the 2 claws to install the No. 1 integration relay to the engine room junction block.


INSTALL NO. 1 RELAY BLOCK COVER
  1. Install the No. 1 relay block cover.

← INSTALLATION (from Aug 2014)COMPONENTS (from Aug 2013) →