2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT FENDER APRON SEAL RH

  1. A223336
    Remove the 4 clips and fender apron seal.


2. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH

  1. A223337
    Remove the 5 clips and fender apron seal.


3. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

  1. A224304
    Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.

  1. A226728
    Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.


4. REMOVE INTAKE PIPE

  1. A224305E01
    Loosen the hose clamp and remove the 2 bolts and intake pipe.


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the bolt from the clamp.

  1. A222715
    Remove the 2 bolts and No. 1 exhaust pipe support bracket.

  1. A222738
    Remove the 3 nuts and front exhaust pipe.

  1. Remove the gasket.


6. REMOVE ENGINE OIL LEVEL DIPSTICK
  1. Remove the oil level dipstick.


7. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
  1. Remove the 2 bolts, guide and O-ring.


8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

  1. A222728
    Remove the 3 bolts and insulator.


9. REMOVE EXHAUST MANIFOLD

  1. A222729
    Remove the 2 nuts, 6 bolts and manifold.

  1. Remove the gasket.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →