2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL SPARK PLUG
  1. Using a 16 mm spark plug wrench, install the 4 spark plugs.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }


2. INSTALL IGNITION COIL ASSEMBLY
  1. Install the 4 ignition coils with the 4 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the 4 ignition coil connectors.


3. INSTALL INTAKE AIR CONNECTOR
  1. Install the intake air connector with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Tighten the hose clamp.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the vacuum hose.

  1. Attach the wire harness clamp.

  1. Connect the No. 2 ventilation hose.

  1. w/ Manifold absolute pressure sensor:

    1. Connect the vacuum hose.

    2. Attach the 2 clamps.

    3. Connect the air pressure sensor connector.


4. INSTALL AIR CLEANER AND HOSE

  1. A246524E01
    Install the air cleaner and hose, align its matchmark with the matchmark of the air cleaner cap as shown in the illustration.
    Text in Illustration 
    *1
    Matchmark
    *a
    Upper
    *b
    Front

  1. Tighten the hose clamp.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Attach the 4 clamps.

  1. Attach the 3 clamps and connect the mass air flow meter connector.

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →