2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE DECK BOARD ASSEMBLY
  1. Operate the 2 rear seat lock release levers and fold down the 2 seatbacks.

  1. B237359E01
    Using a screwdriver, detach the 2 claws and open the cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure to open the cover on the other side.

  1. B239969
    Remove the 2 bolts.

  1. Detach the 4 clips and remove the deck board.


2. REMOVE REAR NO. 4 FLOOR BOARD

  1. B236502E01
    Using a moulding remover, detach the clip and 3 claws.
    Text in Illustration 
    *1
    Guide

  1. Detach the 2 guides and remove the floor board.


3. REMOVE REAR NO. 3 FLOOR BOARD (w/o Rear Air Conditioning System)

  1. B239971E01
    Using a moulding remover, detach the clip and 4 claws.
    Text in Illustration 
    *1
    Guide

  1. Detach the 2 guides and remove the floor board.


4. REMOVE REAR NO. 3 FLOOR BOARD (w/ Rear Air Conditioning System)

  1. B236503E01
    Using a moulding remover, detach the clip and 3 claws.
    Text in Illustration 
    *1
    Guide

  1. Detach the 2 guides and remove the floor board.


5. REMOVE REAR FLOOR MAT SUPPORT PLATE

  1. Remove the 3 bolts.

    B239970E01

    Text in Illustration 
    *1
    Guide
    -
    -

  1. Detach the 4 claws and 2 guides.

  1. Detach the 5 clips and remove the support plate.


6. REMOVE DECK BOARD BRACKET REINFORCEMENT

  1. B240098E01
    Remove the 2 bolts.
    Text in Illustration 
    *1
    Hook

  1. Detach the 2 hooks and remove the reinforcement.


7. REMOVE NO. 1 DECK BOARD BRACKET LH

  1. B237365
    Remove the 2 bolts and bracket.


8. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
  1. Operate the rear seat lock release lever and raise the seatback.

  1. Pull out the seat cushion.

  1. B237367
    Remove the 2 bolts.

  1. B237357E01
    Using a screwdriver, detach the 2 guides and 6 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Guide

  1. B237358
    Remove the 2 bolts.

  1. B236507
    Remove the rear No. 2 seat assembly from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    If removing the seat on the RH side with the LH side installed, remove it with the rear seat leg cover LH raised as shown in the illustration.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →