2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for LHD and RHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE SWITCH BEZEL

  1. B236552E01
    Put protective tape around the switch bezel.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 2 claws.

  1. B236553
    Disconnect the connector and remove the switch bezel.


2. REMOVE REAR POWER SEAT SWITCH

  1. B238956
    Detach the 2 claws and remove the switch from the switch bezel.


3. REMOVE NO. 1 FOLD SEAT SWITCH ASSEMBLY

  1. B236556
    Put protective tape around the No. 1 fold seat switch assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 2 claws.

  1. B236557
    Disconnect the 2 connectors and remove the fold seat switch.


4. REMOVE REAR POWER SEAT SWITCH

  1. B236554
    Detach the 2 claws and remove the switch from the fold seat switch.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →