INSTALLATION
Removal / installation · Vehicles built from Aug 2013
- NOTICE:
- If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (Click here).
- If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU (Click here).
- If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (Click here).
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. INSTALL FOLD SEAT CONTROL ECU |
Install the ECU with the 2 nuts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Connect the 2 connectors.
| 2. INSTALL DECK BOARD ASSEMBLY |
Attach the 4 clips.
Install the deck board with the 2 bolts.
| 3. PERFORM INITIALIZATION |
- NOTICE:
- If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (Click here).
- If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU (Click here).
- If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (Click here).
| 4. CHECK REAR NO. 2 SEAT |
Check the power seat operation (Click here).
