REMOVAL
Removal / installation · Vehicles built from Aug 2013
- NOTICE:
- If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (Click here).
- If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU (Click here).
- If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (Click here).
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE DECK BOARD ASSEMBLY |
Operate the No. 2 fold seat switch and fold down the 2 seatbacks.
Remove the 2 bolts.

Detach the 4 clips and remove the deck board.
| 2. REMOVE FOLD SEAT CONTROL ECU |
Disconnect the 2 connectors.

Remove the 2 nuts and ECU.
